Innovate-motorsports SSI-4 Manuale Utente Scaricare il pdf (Pagina 11)

- 11 -

7. Measuring external 5V sensors

Each of the 5 channels on the SSI-4 can be configured to accept input from an external 0..5V

sensor. Hookup is very straight forward, with ground going to the ‘-‘ input for the channel and the

positive sensor signal going to the ‘+’ input for the channel. Raw sensor data can be converted

into meaningful units and values using the input configuration features of LogWorks on a PC.

8. Programming the SSI-4 with LM Programmer

To connect the SSI-4 for programming follow these steps:

1. Disconnect any MTS device from the IN port.

2. Connect the 2.5mm to DB 2 computer interface cable into the Serial OUT port. Your

computer needs a serial port. If it does not have one, you will need a USB to serial

adapter.

3. Power the SSI-4 either from 12V or a 9V Battery (when using a desktop computer).

4. Start the LM Programmer application

The following screen will show up:

The LM Programmer software then shows in its first page the type and version number of the

firmware of the device.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Nessun commento

Innovate-motorsports SSI-4 Manuale Utente Pagina 11